ATR Percent
Indicator
ATR Percent is Wilder's average true range divided by the close, in percent. It shows the recent range as a share of price.
Created by J. Welles Wilder, 1978. Reviewed by the ChartLabs team, updated Nov 2026.
ATRPercent 0.90
Pane
ATRPercent 0.90
Pane
Illustration on simulated data.
ATR PercentWhat is the ATR Percent indicator?
ATR Percent takes Wilder's average true range and divides it by the close, then multiplies by 100. A reading of 2 means the recent range is about 2 percent of the price. It lets a chart at 100 sit next to a chart at 1000.
The average is seeded with the first bar's true range, which is that bar's high minus its low. A bar with high 10, low 8 and close 10 has a true range of 2, and ATR Percent reads 20. Later bars smooth with alpha 1/14. A close of 0 leaves the bar empty.
The line is #FF6D00, two pixels, in its own panel. There is no source menu: the range uses high, low and the previous close, and the percent uses the close. J. Welles Wilder defined the average in New Concepts in Technical Trading Systems (Trend Research, 1978).
Seeded, not a 14-bar wait
The first bar already has a value. It is that bar's high-low range, divided by the close.
Divided by the close
The same true range is a larger percent on a cheaper price. That is the point of the line.
ATR Percent signalsFive patterns to know.
Line rising
The recent range is a larger share of the close than it was.
Line falling
The recent range is shrinking as a share of price.
One bar lifts it
A wide bar or a gap raises true range, and the average follows with a 14-bar smooth.
Line near a low
Recent bars have covered little ground relative to the price.
Close of zero
A close of 0 has no percent. That bar is empty.
ATR Percent formulaHow it is calculated.
True range
The largest of high minus low, the gap from the high to the previous close, and the gap from the low. The first bar is high minus low.
Smooth it
Wilder's average, seeded with the first true range, then each new bar is (previous average times 13, plus this true range) divided by 14.
Divide by the close
Multiply by 100 and divide by the close. A high of 10, a low of 8 and a close of 10 reads 20 on that first bar. A close of 0 is empty.
ATR Percent settingsEvery setting, explained.
| Setting | Default | Range | What it changes |
|---|---|---|---|
| Length | 14 | 1 to 5,000 | Bars in Wilder's average. The Signal lens changes this. |
| Prices | High, low, close | Fixed | There is no source menu. The percent is of the close. |
| Line | #FF6D00 | Fixed | One orange line, two pixels, in its own panel. |
- Setting
- Length
- Default
- 14
- Range
- 1 to 5,000
- What it changes
- Bars in Wilder's average. The Signal lens changes this.
- Setting
- Prices
- Default
- High, low, close
- Range
- Fixed
- What it changes
- There is no source menu. The percent is of the close.
- Setting
- Line
- Default
- #FF6D00
- Range
- Fixed
- What it changes
- One orange line, two pixels, in its own panel.
Drag to see how the setting changes the lines and how many signals you get. Illustration on simulated data.
ATR Percent strategiesUse it in 3 setups.
A quiet percent, then a break
Bars are covering less ground relative to the price. Traders often look for the bar that expands the range again.
A sudden jump in the percent
One wide bar or a gap lifts the average. It says the range got bigger, not which way to trade it.
Size a stop from the percent
A reading of 2 means the smoothed range is about 2 percent of the close. Traders often scale a stop from that, and the reading is not a target.
ATR Percent mistakesCommon mistakes.
Comparing the raw number across timeframes
A 2 percent range on a daily chart is not the same trade as a 2 percent range on a one-minute chart. Match the length to the bars you trade.
Dividing by a close of zero
That bar is empty. The line does not print an infinite percent.
Treating the first bar as a 14-bar average
The first bar is just that bar's range over its close. The smooth starts from there. A high of 10, low of 8 and close of 10 reads 20.
ATR Percent combinationsPair it with these.
ATR Percent + ATR
ATR is the same average in price. ATR Percent divides it by the close.
ATR Percent + True Range
True Range is the single bar. This line is the smoothed average, as a percent of price.
ATR Percent + Bollinger BandWidth
BandWidth is the Bollinger gap as a percent of the middle band. This is the true-range average as a percent of the close.
ATR Percent + ADX
ADX reads trend strength. ATR Percent reads how large the recent range is against the price.
ATR Percent FAQQuestions traders ask.
What is the ATR Percent setting?
One length, default 14. There is no source. The percent is of the close, and the range uses high, low and the previous close.
What does the first bar show?
That bar's high minus its low, divided by the close, times 100. A high of 10, a low of 8 and a close of 10 reads 20.
How is the average smoothed?
Wilder's way, alpha 1/14. After the first bar, the average is the previous average times 13, plus the new true range, all divided by 14.
What if the close is zero?
That bar is empty. There is no percent of a zero price.
How is this different from ATR?
ATR is in price. ATR Percent is that average divided by the close, so a chart at 100 and a chart at 1000 can be compared.
Does it wait 14 bars?
No. The first bar seeds the average. Later bars fold in with the 14-bar smooth.
Who defined the average?
J. Welles Wilder, in New Concepts in Technical Trading Systems (Trend Research, 1978).
Does it repaint?
No. A closed bar stays. The live bar moves until it closes, because its range and its close can still change.
Related indicatorsMore volatility tools.
All volatility indicatorsTry ATR Percent on a live chart.
Free. No download.
Works in your browser and on iPhone too.